Regency FG39 FireGenie Freestanding Gas Stove
7
LOUVER
INSTALLATION
1) Attach the top & bottom louvres to the
side stove panel using 2 screws per
side.
INSTALLATION
FLUEING
INTRODUCTION
The DV Stove Horizontal Flue Kit and the Simp-
son Dura-Flue Room Sealed System Model DV-
GS fluing systems, in combination with the
Regency Room Sealed Freestanding Gas Stove,
FG39-NG, and FG39-LPG, have been tested
and listed as direct flue heater systems by
AGA.
These units use the "balanced flue" technology
Co-Axial system. The inner liner flues products
of combustion to the outside while the outer
pipe draws outside combustion air into the
combustion chamber thereby eliminating the
need to use heated room air for combustion and
losing warm room air up the chimney.
Note: These flue pipes must not be con-
nected to any other appliance.
The gas appliance and flue system must be
flueed directly to the outside of the building, and
never be attached to a chimney serving a
separate solid fuel or gas burning appliance.
Each direct flue gas appliance must use it's own
separate flue system. Common flue systems
are prohibited.
IMPORTANT
Read all instructions carefully before starting
the installation. Failure to follow these instruc-
tions may create a fire or other safety hazard,
and will void the warranty. Be sure to check the
fluing and clearance to combustible require-
ments. Consult your local building codes before
beginning installation.
The location of the termination cap must con-
form to the requirements in the Exterior Flue
Termination Locations diagram on page 8.
INSTALLATION
PRECAUTIONS
These fluing systems are engineered products
that have been designed and tested for use
with the FG39-NG, and FG39-LPG. The war-
ranty will be voided and serious fire, health or
other safety hazards may result from any of
the following actions:
1) Installation of any damaged Room Sealed
component
2) Unauthorized modification of the Room
Sealed System
3) Installation of any component part not man-
ufactured or approved by Simpson Dura-
Flue or FPI Fireplace Products International
Ltd.
4) Installation other than as instructed by
Simpson Dura-Flue and FPI Fireplace Prod-
ucts International Ltd.
Warning: Always maintain required
clearances (air spaces) to nearby
combustibles to prevent a fire haz-
ard. Do not fill air spaces with insu-
lation.
Be sure to check the flue termination clearance
requirements from decks, windows, soffits,
gas regulators, air supply inlets and public
walkways as specified in the Exterior Flue
Terminal Locations on page 8 and in your local
building codes.
The gas appliance and flue system must
be flueed directly to the outside of the
building, and never be attached to a chim-
ney serving a separate solid fuel or gas-
burning appliance. Each direct flue gas ap-
pliance must use it's own separate flue sys-
tem. Common flue systems are prohibited.
SAFETY
PRECAUTIONS FOR
THE INSTALLER
1) Wear gloves and safety glasses for
protection.
2) Exercise extreme caution when us-
ing ladders or on roof tops.
3) Be aware of electrical wiring loca-
tions in walls and ceilings.