Filter
Top Products
Regency CLASSIC C34-2 Direct Vent Freestanding Gas Heater 7
Diagram 3
Caution: Ensure that the wires do not
touch any hot surfaces.
Note: The #8 ground lug is a dedicated
ground for mobile home use only.
9) Lift the fan assembly in through the pedestal
and up through the cut out as shown in
diagrams 3 and 4.
2) Remove valve cover plate by removing 2
screws.
3) Remove wire from piezo ignitor.
4) Screw the four 8-32 x 3/4 screws provided
into the nutserts as shown in diagram 3. Do
not tighten screws.
5) Push all the fan wires through the hole on
the fan assembly. See diagram 2.
Diagram 2
OPTIONAL FAN INSTALLATION
Diagram 1
1) Open pedestal door and remove door cov-
er plate by removing 4 screws. See dia-
gram 1.
IMPORTANT
Disconnect power supply
before servicing
For leg unit: remove 7 screws, remove
bottom access panel and install fan
assembly, follow steps 4 to 17.
INSTALLATION
For pedestal unit: To install the fan in an
installed stove-access from front
through the pedestal by following the
directions below. If the stove is not
installed - access through rear and
follow steps 4 to 17.
6) Put power cord (shown in diagram 3)
through the hole and pull through to the
front of the unit for easier installation of
ground wire.
7) Place the fan assembly partially in door
cover plate hole. See diagram 2.
8) Attach the 2 ground wires (green) to the
ground lug as per diagram 2.
Note: Ground lug is located on the bot-
tom of the fan assembly. See
diagram 2.
Diagram 4