Filter
Top Products
5
• Make sure to drill the top and bottom
plates for the vertical electrical chases in
the wall panels.
• Do not put plumbing inside SIPs.
• Do not cut the skins (OSB) for extra
electrical chases or plumbing.
• Do not pick up the SIPs by the edge of the
top skin.
• Remove debris from sill plate before you
place the SIP wall panel on it.
• Use mastic on all connections as shown in
the PBS details.
• Make sure that both of the wall SIPs skins
are bearing on the floor.
• Follow proper nailing requirements according
to details and job specific engineering.
• Plumb each SIP in each direction, then secure
with nails.
• Fill all voids with expanding foam.
• Do not apply interior or exterior materials
over wet SIPs.