Philips WP3891 Water System User Manual


 
14
6 Align the arrow on the cap with the arrow
on the lter housing and press the cap down
rmly (1). Turn the cap clockwise to x it (2).
7 Push the lter holder back into place (1) and
close the appliance door (2).
D Note:
Each time you replace the lter, make sure you
also clean the macro lter (see section ‘Cleaning
the macro lter’ above).


dispenser only operates normally again after you

7.0.5 Conrming lter replacement
1 Switch on the pure water dispenser.
If you replaced the lter during the warning
period (between 2700 and 3000 litres),
the lter indicator c ashes. Wait until the
dispense button d starts ashing (ready to
dispense - manual mode).
If you replaced the lter after lter expiry,
the lter indicator lights up continuously.
2 Press and hold the MUSIC button
and then press and hold the dispense
2 Open the appliance door (1). Pull the lter
towards you with the lever (2) and slightly
tilt the lter.
3 Turn the lter cap (1) and remove it (2).
4 Grab the handle on top of the lter (1) and
slowly pull the lter out of the holder (2).
5 Put a new lter in the lter holder.