Filter
Top Products
12
7 Cleaning and
maintenance
7.0.1 Cleaning the pure water dispenser
B Warning:
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol or
acetone to clean the appliance.
B Warning:
Do not pour water over the pure water
dispenser.
1 Clean the outside of the pure water
dispenser regularly with a damp (not wet)
cloth.
2 If you have not used the appliance for 2 days
or more, perform the PureFlush procedure
(see chapter ‘Using the appliance’, section
‘PureFlush’).
7.0.2 Cleaning the macro lter
1 Switch off the pure water dispenser.
2 Turn off the water supply to the pure water
dispenser.
3 Unscrew the water inlet connector (hold it
in vertical position to avoid water spillage)
and pull out the macro lter.
4 Rinse the macro lter under a running tap.
Remove the dirt from the mesh.
5 Put the macro lter back in its original
position.
6 Reattach the water inlet connector.
6.1.2 PureFlush
Use the PureFlush function when you use the
function if you have not used the appliance for
more than 2 days:
dispenser performs the Pure Flush function
maintenance’, section ‘Replacement’).
B Warning:
Do not drink the water that comes out of the
appliance during the PureFlush procedure.
1 Switch on the pure water dispenser.
Wait until the dispense button
d
2 Place a container with a capacity of at least
10 litres under the pure water dispenser.
3 Press and hold the dispense button d for 4
seconds.
The PureFlush procedure starts, during
which 10 litres of water come out of the
appliance.
The dispense button lights up green to
indicate that Pure Flush is in progress.
All other indicators are off.
D Note:
If you want to cancel the ushing procedure
while it is in progress, press the power-on
button y to switch off the pure water dispenser.
•
•