Philips WP3891 Water System User Manual


 
13
8 Insert the tube with the rubber ring in the
UV chamber.
D Note:
Make sure you put the rubber ring and
quartz tube in the correct position.
9 To reattach the UV lamp unit, follow steps 6
to 8 in section ‘Replacing the UV lamp unit’.
10 Close the cover of the UV chamber.
7.0.4 Replacing the lter
D Note:
Switch off the pure water dispenser before you
replace the lter.

When 2700 litres have passed through the

c

the appliance can still dispense another 300 litres



indicator lights up red continuously and the pure
water dispenser does not dispense water until you

D Note:
We advise you to change the lter every
6 months, even though you might not have
consumed 3000 litres. Filter life is subject to the
actual level of impurities in your water supply.
The lter may therefore expire before 3000
litres without any warning period.
1 Switch off the pure water dispenser.
7.0.3 Cleaning the quartz tube
We advise you to clean the quartz tube once
every 6 months.
B Warning:
Handle the quartz tube with care, as it might
break and cause injury. Do not tamper with the
quartz tube (apply glue, etc.).
1 Switch off the pure water dispenser.
2 Open the cover of the UV chamber.
3 To remove the UV lamp unit, follow steps 1
to 5 in section ‘Replacing the UV lamp unit’.
4 Pull out the quartz tube with the rubber
ring.
5 Remove the rubber ring.
6 Clean the quartz tube with a clean moist
cloth and dry it completely.
7 Reinsert the rubber ring to a depth of 2-
3mm from the open end.
ENGLISH