Filter
Top Products
Note: Do not adjust the hinge with the top and bottom screws loose; this could force the
hinge to adjust beyond its design capability which can cause the hinge to bind, damage
the hinge and/or pull out the screws. A ¾ turn of the center screw provides approximately
5/32" adjustment.
P. Doors with a lock strike in the side (jamb) and without a sidelight on the lock side:
Drill an 1/8" diameter x 2" deep pilot hole into the rough opening through the pre-drilled
holes located in the frame as follows:
P1. Door Frame Corner:
Drill pilot holes through the pre-drilled hole located in the upper frame corner on the lock
jamb side, approximately 8" from the top of the door frame head.
P2. Doors with Multi-point Lock:
Drill through the one pre-drilled hole located in each lock strike. (Pull back frame
weatherstrip to locate open hole in strike).
P3. Center Latch and Deadbolt Lock:
Drill through the mounting hole locations. Insert a # 8 x 3" screw into the pilot holes
making sure it passes through the shim and into the rough opening.
Note: This step does not apply to center latching double doors.
3
SETTING AND FASTENING THE DOOR (continued):
3O
Head
~ 8”
J
a
m
b
3P1
4
INTEGRATING THE DOOR TO THE WATER
RESISTIVE BARRIER:
A. Apply side flashing tape. Cut two pieces of
flashing tape 4" longer than the frame height of
the door. Apply one piece 1/2" onto the frame
cladding, over the nailing fin and onto the water
resistive barrier on each side. The tape should
extend 2" above the top of the door and 2" below
the bottom of the door. Press the tape down firmly
while folding down the excess tape at the top and
bottom of the door.
Exterior
4A
Note: The flashing tape must be applied approximately
1/2" onto the frame cladding at the jambs and head.
Pre-folding the tape at 1/2" before removing the paper
backing will make it easier to apply the tape correctly. If
the siding is less than 1/2" thick, adjust the dimension of
the fold so the exterior sealant line will cover the exterior
edge of the tape.
3O
3P
3P3
3P
3P
3P2
3P2
Pull back weatherstrip to expose strike hole.
Flashing
Tape