Pella 80YV0102 Window User Manual


  Open as PDF
of 14
 
B1
B2
Spline
hole
B. Remove Interior Frame Cover #1. IfanInteriorFrameCoverhasa"QuickReleaseBand"
around the cover, pull the band to help remove the cover.
The cover on vent units where the lock handle slot is located and the cover on the
opposite frame side.
Note: Interior Frame Covers #1 are jamb covers on Casement, Fixed Awning/Casement
and Large Awning units. On Standard Awning units, Interior Frame Covers #1 are the
head and sill covers.
1. Approximately1"fromthe
bottom(end)ofthecover,insert
the"hooked"endofthetool
between the cover and the sash.
2. Rotatethetooltowardthesash
and continue to insert the tool
past the spline hole up to the
point where the bend in the
tool is aligned with the edge
of the cover.
Note: When the tool is inserted with the bend aligned with the cover edge there
will be a slight gap between the tool and the face of the sash.
3. Pushthetoolatagainst
thesash(notalotofforceis
needed)toreleasetheback
cover barb from the frame
kerf behind the cover. While
keeping tension on the tool,
pull the tool away from the
frame to start releasing the
cover barbs from the frame
kerfs.
B3
Cross Section of
Interior Frame Cover with
Tool Placement Detail
Barb released
from kerf
B3
Sash
Tool
Cover
AWNING/
CASEMENT
4. Rotatethecoverendslightlytowardtheinterior;whenthe
cover begins to pull away from the frame, relocate the tool
under the cover towards the interior as shown, then pull
the tool away from the frame to continue the release of the
cover barbs from the frame.
5. Repositionthetoolwiththehookunderthefrontedge
of the cover. Slide the tool over while pulling the cover
away from the frame. This will release the flexible barbs
on the interior side of the cover, which will aid in cover
removal. Continue sliding along the length of the cover
while pulling it away from the frame until it is removed.
6. RepeatStepsB1thruB5to
remove the other Interior
FrameCover#1.
If installing a single Casement,
Large Awning or Fixed unit less
than 42" in width, go to Step E.
B4
Flexible barbs
B5
Lock handle slot
B5
If installing a Standard Awning, multiple window combinations, or units greater than 42"
in width, go to Step C.
 previous next