Pella 80YV0102 Window User Manual


 
Note: On the exterior, there must be enough room for backer rod and 3/8" sealant
bead.
N. Insert shims between the window and the
opening at the top two anchor hole locations
inthewindowjambs.Keepshimsback1/2"
from interior face of window.
M. Insert the window and center it in the opening to allow
clearance for shimming.
Note: Use of a suction cup on the glass will assist in
handling the window.
Note: Each existing window frame and wall depth will vary
in different applications; therefore there is not a standard
measurement for the overhang of the window frame to
the exterior or for the distance from the interior face of the
window to interior trim. When performing Steps 4B thru 4D,
installing the frame screws, be sure to keep the distance
consistent all around the window.
NOTE 4M
Note: Position shims to ensure they allow at least 1/2" from the exterior surface of the
window to allow for placement of backer rod and sealant.
O. If additional installation holes are needed;drilla5/32”installationholethrough
boththeinteriorandexteriorwallsoftheframe.Counterdrilla3/8”holethroughthe
interiorwallonlyoftheframe.DONOTpenetratetheexteriorwallwiththe3/8”bit.
P. Fasten the window near the top of the opening by
driving2-1/2"longwoodscrewsthroughthetoptwo
holes at the jambs and into the opening sides.
Q. Plumb and square the window. Insert shims between
the window frame and the rough opening at the
anchor hole locations in the window frame. Keep
shimsback1/2"frominteriorfaceofwindow.
Note: DO NOT shim above the window or in the
space between the spacers at the bottom of the
window. DO NOT over shim.
4M
4P
Shim
2-1/2" Screw
4R
1
20 30 40 5 0 60 70
2 3
INCHES
mm
SINGLE-
HUNG
and
DOUBLE-
HUNG
SINGLE-HUNG and DOUBLE-HUNG
Interior
4Q
R. Check the interior reveal. Make
sure the measurement from the
interior face of the window to
the interior face of the window
to the interior face of the wall is
equal at several points around
the window.
4O
Double-Hung
3/8"
5/32"
Single-Hung
4O
3/8"
5/32"
EXTERIOR
EXTERIOR