Pella 80YV0102 Window User Manual


  Open as PDF
of 14
 
Any exposed wood and flashing tape on the exterior needs to be
covered/protected. There are many ways to accomplish this, and
each case can be unique.
Afewpossibilitiesinclude:
a) Coveringtheexistingtrimwithaluminumcoilwrap/
frame expander.
b) Sanding,primingandpaintingtomatchexistingtrim.
c) Coveringtheexposedwoodwithahighqualityexterior
grade sealant.
Note: The contractor/installer will determine how to finish
the exterior.
EXTERIOR FINISH OF EXISTING FRAME
EXTERIOR OF WINDOW
WITH FRAME EXPANDER
INSTALLING ROTO COVER AND CRANK
A. Place the cover over the operator stud and snap
into place.
B. Apply pressure to the pocket end of the cover and
snap into place.
C. Useamediumsizeat-bladescrewdriverto
loosen the set screw in the crank handle.
D. Slidethecrankhandleontothestud.Unlock,
open window, then close and lock window.
E. Fold the crank handle down and check
alignment of knob with the pocket.
Note: You may need to adjust the crank
position on the stud until the correct alignment
is achieved.
F. Open the crank and tighten the set screw.
G. After the final installation, fold the crank over
and snap the knob into the pocket.
Note: Even with the window open the crank
can be folded to avoid interfering with the
window treatments.
Crank Handle
Operator Stud
Set Screw
Knob
Pocket
D
C
E
Pocket End
Operator Stud
B
A
AWNING/
CASEMENT
C. Begin the sill sealant bead 1/2" from one jamb, running it across the sill and stopping
1/2"fromtheoppositejamb.This1/2"sealantgaponeachsideofthesillallowsfor
incidental water drainage.
D. Shape, tool, and clean excess sealant. When finished, the sealant should be the shape
of an hourglass.
Note: This method creates a more flexible sealant line capable of expanding and
contracting.
 previous next