Filter
Top Products
34 C2445M-E (11/05)
ENABLE MOTION DETECTION
The following are the settings for MOTION DETECTION ENABLED:
OFF (default) Motion detection is turned off (disabled).
ON Motion detection is turned on (enabled).
NOTE: Motion detection does not work if the shutter speed is set at less than 1/60 of a second.
EDIT DETECTION AREAS
Four motion detection areas can be defined for a preset. Use the following steps to edit motion
detection areas.
1. Edit detection areas 1, 2, 3, or 4:
a. Use the joystick to position the cursor beside EDIT DETECTION AREAS.
b. Press Iris Open. The EDIT DETECTION AREAS programming window appears on the
monitor.
c. Use the joystick to position the cursor beside LOCATION for DETECTION AREA 1, 2,
3 or 4.
d. Press Iris Open. The cursor moves to the right next to the number 0.
e. Move the joystick up. A blue rectangle appears in the upper left-hand corner of the
screen.
f. Use the joystick to place the blue rectangle over the desired detection area.
g. Press Iris Open to make a selection.
2. Set the sensitivity of the motion detection area:
a. Position the cursor next to SENSITIVITY for DETECTION AREA 1, 2, 3 or 4.
b. Press Iris Open, the cursor moves to the right.
c. Use the joystick to select one of the following sensitivity levels:
HIGH The sensitivity level is high. Slight changes in light
level and contrast are detectable.
MEDIUM (default) Average sensitivity.
LOW The sensitivity level is low.
d. Press Iris Open to make selection.
PRESETS
PRESET NUMBER 1
* * * PRESET NOT DEFINED * * *
<EDIT PRESET LABEL>
<EDIT PRESET SCENE>
<EDIT CAMERA SETTINGS>
<MOTION DETECTION>
<CLEAR PRESET>
<CLEAR CAMERA SETTINGS>
BACK
EXIT
REFERENCE INFORMATION
AZIMUTH -
ELEVATION -
ZOOM RATIO -
CUSTOM CAMERA SETTINGS -
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
BACK
EXIT
DOME SETTINGS
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
MOTION DETECTION ENABLED ON
<EDIT DETECTION AREAS>
ACTIVATE AUX OFF
AUX TIME (SECS) 0
MOTION DETECTION
EDIT DETECTION AREAS
DETECTION AREA 1
LOCATION 0
SENSITIVITY MEDIUM
DETECTION AREA 2
LOCATION 0
SENSITIVITY MEDIUM
DETECTION AREA 3
LOCATION 0
SENSITIVITY MEDIUM
DETECTION AREA 4
LOCATION 0
SENSITIVITY MEDIUM
BACK
EXIT
*This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.
C2445M-E.pmd 12/14/05, 8:45 AM34