Filter
Top Products
10 C3426M-A (5/07)
Cover and Back Box Installation
The IS110 Series Camclosure integrated camera system mounts only to a surface. It can be wired
through the cover into a surface, electrical box, or plaster ring. You can also wire it through a side
conduit.
UNSHIELDED TWISTED PAIR (UTP) VIDEO
The IS110 Series offers support for unshielded twisted pair (UTP). The UTP video output signal is
1 Vp-p differential into a 100-ohm load. At a minimum, UTP requires Cat5, 100-ohm twisted pair
cable.
BASIC SURFACE INSTALLATION
NOTE:
You should install the camera module into the back box before installing the back box into the
cover. When installing the back box into the cover, rotate the camera module to access the mounting
holes (refer to
Camera Module
on page 16 for more information).
1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the
cover from the back box.
2. Using the cover as a template, mark one of the large holes on the mounting surface.
3. Cut out the hole for the power and video wiring.
4. Pull the video and power wires through the hole in the cover.
5. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel
hardware when installing the system outdoors.
6. Connect the video cable/wires:
•
BNC:
Connect the BNC connector from the unit to a mating BNC connector.
•
UTP:
Blue wire = Video +
Gray wire = Video -
7. Connect the power wires.
AC operation only:
If you are wiring more than one Camclosure to the same transformer,
connect one side of the transformer to the red wire on all units; connect the other side of the
transformer to the black wire on all units.
NOTE:
Failure to connect all AC powered units the same way will cause the cameras to be out
of phase with each other and may produce a vertical roll when switching between cameras.
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~