Filter
Top Products
22 36ARB2 050505-36
FIREBOX PANELS INSTALLATION
(HERRINGBONE ..................TCPN.7566)
(TUSCAN ................................TCPN.748)
(HERITAGE RED ................TCPN.75704)
For porcelin panel kit (TCPN.75702) installation see in-
structions provided with panel kit.
The Firebox Panels have to be installed for safe operation.
Do not use the replace without panels. Unpack and inspect
all panels. The panels need to be installed before the logs
are in place.
Caution: The Brick Panels are very fragile, and should be
handled with care.
1) Remove the log grate by removing the two screws retaining
it. Screws are located behind the front legs of the grate.
2) Remove the Side Panel Retainers located on the underside
of the upper rebox heatshield. The retainers are each
held in place by one screw.
3) Install the Lower Rear Panel.
4) Install the Right Side Panel by inserting the bottom of the
panel in rst and then angling it up into position.
5) Install the Left Side Panel by inserting the bottom of the
panel in rst and then angling it up into position.
The rear panel is held tight against the side panels by two "V"
brackets located on the rebox rear wall. Although the brackets
are adjusted at the factory for the best t, some adjustment
may be necessary. Adjust the angle of the bracket by hand
to ensure a snug t.
Fig. #32
Fig. # 31
LEFT SIDE
PANEL
RIGHT SIDE
PANEL
REAR UPPER
PANEL
REAR LOWER
PANEL
LEFT FRONT
PANEL
RIGHT FRONT
PANEL
REAR LOWER PANEL
ADJUSTABLE "V" BRACKET
6) Install the Rear Upper Panel.
7) Re-install the Side Panel Retainers.
8) Install the Left and Right Front Panels.
9) Replace the Grate.
HERRINGBONE PANEL SET SHOWN