Filter
Top Products
For maximum cleaning perfor-
mance, the following carpet height
settings are recommended.
Cleaners with Two Settings:
• Setting 1 (A): for bare floors and all
carpet types.
• Setting 2 (B): if easier pushing effort
is desired while maintaining good
cleaning performance.
Cleaners with Four Settings:
• Lowest setting (1): for bare floors
and low pile, level loop, kitchen type
carpet.
• Next setting (2): for other types of
carpet.
• Higher settings (3-4): for very deep
pile carpet where easier pushing effort
is desired, while maintaining good
cleaning performance.
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
For ease in sliding knob, the handle
should be in the upright position (B).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (C).
If it is necessary to raise and lower the
nozzle for various carpet pile heights,
slide the nozzle control knob to the
desired setting.
Carpet height adjust-
ment
The cleaning of carpet and rugs takes
place at the nozzle (A).
The cleaner can also be moved by
lifting it as shown.
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position,
tilt cleaner back on rear wheels, and
push forward.
7
33
34
35
32
31
30
A
B
(B)
(A)
C
(1)
(2)
(3)
(4)