Filter
Top Products
20
W415-0429 / C / 11.04.05
1. Turns electric flame on/off.
2. Turns gas flame on/off.
3. Activates gas flame adjustment.
4. Activates fan adjustment.
5. Adjusts options #3 & #4 up.
6. Sets the timer.
7. Adjusts options #3 & #4 down.
8. Sets the time.
To operate the gas features, the pilot needs to be running
and the gas valve turned to the on position.
You can run the fireplace on manual or remote.
When operating the main burner on manual,
the fireplace will operate on low input only.
Turn the respective main power switches to manual to
operate either the gas or the electric features of the fire-
place without the remote or thermostat.
Turn both the main power switches to remote to operate
either the gas or the electric features of the fireplace with
the remote or thermostat.
Turn both the main power switches to the off position to
disable either the gas or the electric features of the fireplace.
In order to save the battery life on the remote,
it is recommended that when operating the
electric fireplace for an extended period of time,
to operate with the electric power switch in the
manual position.
EMBER BED BULB REPLACEMENT
1. Remove the lower control panel by removing the 8 se-
curing screws.
OPERATION
FIREPLACE OPERATION
HAND HELD REMOTE OPERATION
2. Hold the lower portion of the light socket and turn
clockwise to remove.
3. Pull the bulb straight out of the socket and replace the
bulb being careful not to touch the quartz portion with your
fingers.
4. To put back together, reinstall the control panel removed
in step 1.
LIGHT SOCKET
FIGURE 47
FIGURE 48
FIGURE 50
GAS
FIGURE 49