Filter
Top Products
18
W415-0429 / C / 11.04.05
4. Place the bottom of log #6 against the right side of the
firebox. The upper branch rests against log #1. The lower
branch rests against the 4th and 5th grate posts.
Remove the backing of the
logo supplied and place on the
glass viewing door, as
indicated.
½"
½"
LOGO
FIGURE 40
PHAZER
TM
logs and glowing embers exclusive to Napoleon Fire-
places, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully po-
sition the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
1. Place rear logs #1 & #2 against the back of the firebox
with the notch in the bottom of log #2 around the pilot
assembly, as shown.
2. Place logs #3 and #4 onto the locating pins on the burner.
3. Place the bottom of log #5 against the left side of the
firebox. Rest the log back, diagonally into the designated
pocket in log #1.
FIGURE 38a-d
CHARCOAL EMBERS
GLOWING EMBERS
LOGO PLACEMENT
Randomly place the charcoal embers along the front and
sides of the log support tray in a realistic manner. Fine
dust found in the bottom of the bag should not be used.
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of the small
logs (#2 & #3). Care should be taken to shred the embers
into thin, small irregular pieces as only the exposed edges
of the fibre hairs will glow. The ember material will only
glow when exposed to direct flame; however, care
should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
TM
logs glow
when exposed to direct flame. Use only certified "glowing
embers" and PHAZER
TM
logs available from your Napo-
leon dealer.
LOG PLACEMENT
2
3
4
5
6
Place the glowing crystal embers along the front of the log
support on the glass only. Make sure the glowing crystal
embers don't block the gap between the burner and the
glass.
DO NOT PLACE GLOWING CRYSTAL EMBERS
ON THE BURNER.
GLOWING CRYSTAL EMBERS
1
GLOWING CRYSTAL EMBERS
FIGURE 39