Filter
Top Products
19
W415-0434 / C / 03.24.05
The FIRE LOG ACCENT LIGHT is provided with a manual "in-
line" switch to turn the light on and off. There are alternate meth-
ods of operating the light.
An example of one method would be to "hard-wire" a wall switch.
The switch could be installed in desired location to operate the
FIRE LOG ACCENT LIGHT plugged into one of the two recepta-
cles on the fireplace junction box. The other receptacle would still
have power to operate other accessories (see schematic be-
low).
This switch could be:
• Toggle
• Photo cell
• Remote
• Motion Sensor
All switches are available at your building store.
NOTE
ELECTRICAL INSTELECTRICAL INST
ELECTRICAL INSTELECTRICAL INST
ELECTRICAL INST
ALLALL
ALLALL
ALL
AA
AA
A
TION TTION T
TION TTION T
TION T
O BE DONE BY AO BE DONE BY A
O BE DONE BY AO BE DONE BY A
O BE DONE BY A
QUQU
QUQU
QU
ALIFIED INSTALIFIED INST
ALIFIED INSTALIFIED INST
ALIFIED INST
ALLER ALLER
ALLER ALLER
ALLER
and mand m
and mand m
and m
ust be connected andust be connected and
ust be connected andust be connected and
ust be connected and
gg
gg
g
rr
rr
r
ounded in accorounded in accor
ounded in accorounded in accor
ounded in accor
dance with local codesdance with local codes
dance with local codesdance with local codes
dance with local codes
..
..
.
Your Napoleon STARfire comes equipped with our “Accent
Lite”. The light has been pre-wired and can be controlled
from the switch on the control panel.
It is recommended that the ACCENT LITE be in the off
position when the fireplace is on.
If in the event the lamp
or lens needs to be
replaced, follow the
instructions below.
Unplug the light from
inside the fireplace.
Remove the four screws that secure the lens frame.
This frame
retains the
glass lens.
The lamp can
now be
accessed.
Note:Note:
Note:Note:
Note:
Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers,
Do not handle the lamp (bulb) with bare fingers, Do not handle the lamp (bulb) with bare fingers,
Do not handle the lamp (bulb) with bare fingers,
protect with a clean dry cloth.protect with a clean dry cloth.
protect with a clean dry cloth.protect with a clean dry cloth.
protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with
Wolf Steel parts only, as lamp and lens are special “high
temperature” products.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
OvOv
OvOv
Ov
er tightening the screr tightening the scr
er tightening the screr tightening the scr
er tightening the scr
ee
ee
e
ws could brws could br
ws could brws could br
ws could br
eak the lenseak the lens
eak the lenseak the lens
eak the lens
..
..
.
“Light Leakage” from the upper louvre area may be“Light Leakage” from the upper louvre area may be
“Light Leakage” from the upper louvre area may be“Light Leakage” from the upper louvre area may be
“Light Leakage” from the upper louvre area may be
noticed. The holes in the lamp housing are necessarynoticed. The holes in the lamp housing are necessary
noticed. The holes in the lamp housing are necessarynoticed. The holes in the lamp housing are necessary
noticed. The holes in the lamp housing are necessary
for ventilation and must not be covered.for ventilation and must not be covered.
for ventilation and must not be covered.for ventilation and must not be covered.
for ventilation and must not be covered.
ACCENT LITE REPLACEMENT
FIGURE 47
FIGURE 49
IN LINE SWITCH
FIGURE 50a
FIGURE 50b
LENSE
ASSEMBLY
FIREBOX TOP
LENSE
ASSEMBLY
FIREBOX TOP
SCREWS
SCREWS
FIGURE 48