Filter
Top Products
18
W415-0434 / C / 03.24.05
Glowing embers (not supplied) maybe used to enhance
the flame's appearance.
4. Place log #4, with the charred branch pointed inward.
Locate the pins into the holes in log#1 and log#2, this will
hold the rear log in position.
5. Place the end of log #5 on the right end of log #1. The
fork in the log should straddle the knot on top of log #2.
GLOWING EMBERS
BAFFLE INSTALLATION
CHARCOAL EMBERS
PHAZER
TM
logs, exclusive to Napoleon Fireplaces, pro-
vide a unique and realistic glowing effect that is different in
every installation.
1. Centre the two charcoal strips, as shown, along the
inside front edge of the firebox.
Place the rear log #1 onto the locating studs along the
back edge of the PHAZERAMIC™ burner.
2. Position log #2 onto the locators on the PHAZERAMIC™
burner.
3. Position log #3 onto the right most grate rail with the
charred face to the front. Align the groove on the underside
of the log, with the rail of the grate. Push the log back to the
pilot housing. Log #3 should fit tight against log #2.
LOG PLACEMENT
2
3
4
FIGURES 46a-e
1
CHARCOAL STRIPS
5
Your fireplace has been supplied with the decorative brick
panels installed. It will be necessary, however, to install the
fibre baffle, on top of the side and rear panels.
Charcoal provided should be randomly placed in the trian-
gular trays on either side of the of the burner.
Log colourLog colour
Log colourLog colour
Log colour
ss
ss
s
mama
mama
ma
y vy v
y vy v
y v
aryary
aryary
ary
. During the initial use of. During the initial use of
. During the initial use of. During the initial use of
. During the initial use of
the f the f
the f the f
the f
irir
irir
ir
e-e-
e-e-
e-
place, the colours will become more uniform as colourplace, the colours will become more uniform as colour
place, the colours will become more uniform as colourplace, the colours will become more uniform as colour
place, the colours will become more uniform as colour
pigments burn in during the heat activated curing pro-pigments burn in during the heat activated curing pro-
pigments burn in during the heat activated curing pro-pigments burn in during the heat activated curing pro-
pigments burn in during the heat activated curing pro-
cesscess
cesscess
cess
..
..
.
Positioning the logs improperly will cause flame im-
pingement and carboning.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
TM
logs glow
when exposed to direct flame. Use only certified PHAZER
TM
logs available from your Napoleon dealer.