Filter
Top Products
2
W415-0614 / A / 07.24.07
PG2-5 INTRODUCTION
Warnings and Safety Precautions
Warranty
Dimensions
General Instructions
General Information
Care of Glass & Plated Parts
5-9 VENTING
Vent lengths
Venting Specifi cations
Air Terminal Locations
10-14 INSTALLATION/FRAMING
Wall & Ceiling Protection
Using Flexible Vent Components
Fireplace Vent Connection
Gas Installation
Restricting Vertical Vents
Framing
Clearance to Combustibles
Mantle Clearances and Enclosures
14 ELECTRICAL CONNECTION
Schematic
15-18 FINISHING
Door Removal
Log Shipping Bracket Removal
Brick Panel Installation
Andiron Placement
Log Placement
Charcoal Embers
Night Light Replacement
19 REMOTE AND VALVE ACCESS
Remote Removal
Valve Removal
20-24 OPERATION / MAINTENANCE
Fireplace Operation
Hand Held Remote Operation
Temperature Display
Room Thermostat
SMART Thermostat
Flame Height
Fan Shield
Child Proof Function
Remote Auxiliary Outlet
Low Battery / Manual Bypass
Operating Instructions
Maintenance
24 ADJUSTMENTS
Pilot Burner Adjustment
Venturi Adjustment
Air Control Rod Access
25-26 REPLACEMENTS
Ordering Replacement Parts
Replacement Parts
Terminal Kits
Vent Kits
Accessories
27-28 TROUBLE SHOOTING GUIDE
29 SERVICE HISTORY
30 NOTES
WARNING
• Do not burn wood or other materials in this fi replace.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or cloth-
ing ignition. Supervise young children when they are in the same room as the fi replace.
• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
• Due to high temperatures, the fi replace should be located out of traffi c and away from furniture and draperies.
• Clothing or other fl ammable material should not be placed on or near the fi replace.
• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens
and guards must be fastened to the fl oor.
• Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace.
• Even after the fi replace is out, the glass and/or screen will remain hot for an extended period of time.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the fi replace and venting system are
kept clean. The fi replace and its venting system should be inspected before use and at least annually by a qualifi ed service person. More
frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fi replace area must be kept clear and
free from combustible materials, gasoline and other fl ammable vapours and liquids.
• Under no circumstances should this fi replace be modifi ed.
• This fi replace must not be connected to a chimney fl ue pipe serving a separate solid fuel burning appliance.
• Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the fi replace and to
replace any part of the control system and any gas control which has been under water.
• Do not operate the fi replace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or
qualifi ed service person.
• Do not strike or slam shut the fi replace glass door.
• This fi replace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.
•
Only doors/optional fronts certifi ed with the appliance shall be used.
• Pressure relief doors must be kept closed while the fi replace is operating to prevent exhaust fumes containing carbon monoxide, from
entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials
to overheat and catch fi re.
TABLE of CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE