Filter
Top Products
17
W415-0614 / A / 07.24.07
6. Place the pin in log #7 in the hole in log #6. The log
should sit in the notch on log #2 and the bottom should
rest along the right side of the Andiron.
7. Place the large end of log#8 into the rear notch of
log#4.
The small branch of log#8 sits in the notch located on
top of log#1.
8
PHAZER™ logs and glowing embers, exclusive to NA-
POLEON® Fireplaces, provide a unique and realistic
glowing effect that is different in every installation. Take
the time to carefully position the glowing embers for a
maximum glowing effect. Log colours may vary. During
the initial use of the fi replace, the colours will become
more uniform as colour pigments burn in during the heat
activated curing process.
LOG PLACEMENT
1. Center the rear log (#1) behind the rear burner and onto
the log support.
8. Place log#9 onto the grate as though it had burnt
off log#5. Place log#10 onto the locating pin on log#1.
Again, log#10 should be aligned as though it has burnt
off of log#7.
2. Place log#2 and log#3 onto the locating pins. The logs
should sit fl at on the burner.
3. Place the locating hole on the underside of log#4 onto
the locating pin on top of log#3. The notch at the oppo-
site end of log#4 sits on the third grate post in from the
right side.
4. Place the small branch of log#5 into the notch on log#3.
The notches on the bottom edge of log #5 should sit on
the fi rst and second grate posts from the left.
5. Place the small end of log#6 into the front notch of
log#4. Place the locating hole in the large end of log#6
onto the locating pin on top of log#2.
1
2
3
4
5
6
7
9
10
ANDIRON PLACEMENT
Andirons are pack-
aged seperately in-
side the unit and must
be installed prior to
the log installation.
Place the Andiron on
the Andiron brackets
located at the front of
the unit lining up the
holes. Secure using
the screws provid-
ed. Repeat on other
side.