Filter
Top Products
19
W415-0580 / C / 04.07.08
6. Place the pin in log #7 in the
hole in log #6. The log should sit
in the notch on log #2 and the
bottom should rest along the
right side of the Andiron.
8
PHAZER™ logs and glowing embers, exclusive to Wolf Steel Ltd.Fireplaces, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colors
may vary. During the initial use of the fi replace, the colors will become more uniform as color pigments burn in during the heat
activated curing process.
LOG PLACEMENT
1. Center the rear log (#1) behind
the rear burner and onto the log
support.
8. Place log#9 onto the grate as
though it had burnt off log#5. Place
log#10 onto the locating pin on
log#1. Again, log#10 should be
aligned as though it has burnt off
of log#7.
2. Place log#2 and log#3 onto the
locating pins. The logs should sit
fl at on the burner.
3. Place the locating hole on
the underside of log#4 onto the
locating pin on top of log#3.
The notch at the opposite end
of log#4 sits on the third grate
post in from the right side.
4. Place the small branch of log#5 into
the notch on log#3. The notches on
the bottom edge of log #5 should sit
on the fi rst and second grate posts
from the left.
5. Place the small end of log#6 into
the front notch of log#4. Place the
locating hole in the large end of
log#6 onto the locating pin on top
of log#2.
1
2
3
4
5
6
7
9
10
ANDIRON PLACEMENT
Andirons are packaged separately inside the unit and must be installed prior to the log
installation. Place the Andiron on the Andiron brackets located at the front of the unit lining
up the holes. Secure using the screws provided. Repeat on other side.
FIGURE 39
FIGURE 40a-h
7. Place the large end of log#8 into
the rear notch of log#4.
The small branch of log#8 sits in the
notch located on top of log#1.