Filter
Top Products
16
W415-0580 / C / 04.07.08
RECEIVER
Receiver
12 Pin
Connector
110V OUT
Receiver Hearth Mount
OFF
ON
REMOTE
TPTH
TP
TH
FCM-COM
FAN AUX OUT
Red
Black
MOTOR
Green
White
Fan Control Module (FCM)
OUT
Modulating 820
Night Lights
ON
OFF
REMOTE
Receiver Wall Mount
BLOWER
FIGURE 30
MINIMUM MANTEL AND ENCLOSURE CLEARANCES
Combustible mantel clearance can vary according to the mantel
depth. Use the graph to help evaluate the clearance needed.
Do NOT use the fireplace if any part has been under water.
Call a qualified service technician IMMEDIATELY to have the fire-
place inspected for damage to the electrical circuit.
If access to the control area is necessary BEFORE INSTALLATION,
remove the access panel. Located along the right side of firebox.
The access panel must be re-installed before operating the unit.
It is necessary to hard wire this fireplace.
Permanently framing the fi replace with an enclosure, requires the fi re-
place junction box to be hard wired.
This fi replace must be electrically connected and grounded in accor-
dance with local codes. In the absence of local codes, use the current
CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/
NFPA 70-1996 NATIONAL ELECTRICAL CODE in the United States.
ELECTRICAL CONNECTION
HARD WIRING CONNECTION
SCHEMATIC
FIGURE 32
IMPORTANT:
The requires a minimum inside enclosure height of 84”
measured from the bottom of the fi replace.
For temperature requirements, this area must be left unobstructed.
It is recommended that the enclosure be ventilated at the top and
bottom to circulate the hot air with 2, 40” square openings.
0
34 7
8
9
12 56
7
H
E
I
G
H
T
M
A
N
T
E
L
MANTEL DEPTH
5
6
4
3
FIGURE 31a-b
* See Venting Section
** Within the fi replace enclosure a 9” clearance between the vertical vent run and the combustible materials on the front facing of the enclosure
is required. Similarly, a 5” clearance to combustible materials from the top of the horizontal vent run is required. All other clearances within the
enclosure, including where the vent pipe exits the enclosure are subject to 2” for horizontal and 1” for vertical.