Filter
Top Products
17
W415-0580 / C / 04.07.08
Before the glass door can be removed,
the control doors must be opened and
the hearth strip and screen assembly
must be removed.
LOG SHIPPING BRACKET
DOOR REMOVAL
HEARTH STRIP
RETAINER
C
O
N
T
R
O
L
D
O
O
R
S
LOG SHIPPING
BRACKET
FIGURE 33
H
O
O
K
S
ROD
FIGURE 34
SCREWS
FIGURE 35
FINISHING
Before installing the logs, you must fi rst remove the log shipping bracket. Lift up to remove.
Discard once removed.
With the control doors pulled open,
you can now lift the hearth strip up and
away from the front of the fi replace. The
curtain assembly can be removed by
lifting the rod out from the three hooks
at the top inside edge of the door open-
ing.
FIGURE 36
LOG
SHIPPING
BRACKET
1. Place the door frame face down careful not to scratch the paint.
2. Center the gasketed glass inside the door frame with the thick side of the
gasket facing up.
3. Bend the glass retainers located along the edge of the door frame over the
gasket holding the glass in place. Careful not to break the glass.
GLASS/DOOR REPLACEMENT
GLASS
GASKET
DOOR FRAME
GLASS
RETAINER
FIGURE 37
The glass door is secured to the fi rebox with 7
latches. 2 on each side, and 3 across the top plus
2 screws. Pull the handle of the latch forward,
then lift the hooks out from the slot in the door
frame to release the top and sides of the door.
Using a Screw Driver remove the 2 screws in the
bottom corners of the door. Lift the door out from
the retainer along the bottom of the door. We
recommend 2 people remove door due to size and
weight. Pull the bottom edge of the door out from
the fi replace until the top will pivot forward. Handle
carefully as the door is extremely heavy.
NOTE: Care must be taken when removing and disposing of any broken glass or
damaged components. Be sure to vacuum up and broken glass from inside the
fi replace before operation.