Filter
Top Products
23
W415-0299 / J / 04.14.08
PHAZER
TM
logs, glowing and charcoal embers, exclusive
to Wolf Steel Ltd. fi replaces, provide a unique and realistic
glowing effect that is different in every installation. Take the
time to carefully position the embers for a maximum glowing
effect. Figures 49 A - H.
1. Looking at the unit from the valve side, place log #1 di-
agonally across the textured burner cover onto the pins. The
texture is designed to cradle the underside of the log.
2. Depending on the type of installation, the view of the log
positioning will reverse. Here the lower end of log #2 rests
near the back left corner of the fi rebox on the locating pin.
The upper end sits on top of log #1, inside the groove on
log #2.
3. Log # 3 is made up of
two pieces, a and b. Piece
#3a is the base of log #3.
The base sits diagonally in
the designated area located
between logs #1 and fi ts tight
up against #2.
4. The slot in the under-
side of piece #3b fi ts over
#3a. Place the end of piece
#3b onto the pin.
5. When pieces #3a and #3b are attached to create log #3,
the upper end of log #3 should rest in the groove, on top of
log # 2.
6. As with log # 1, log #4 is also cradled by the texture of
the burner cover and the pin in the base. Position log #4
so that the lower end fi ts onto the pin. The upper end rests
against the moulded locater on the top of log # 1.
7. Like log #3, log
#5 also comes in
two pieces. The
base (#5a) slopes
outwards between
logs #2 and #4.
As with pieces #3a
& b, piece #5b fi ts
over piece #5a.
Place the end of
piece #5b onto the
pin.
8. The upper end of log #5 rests in the groove, on top of log
#4 and creates the fi nal appearance of log set.
A
D
B
#3
#5
A
B
G
#3
E
A
LOCATING PINS
#1
LOCATING PINS
#2
B
C
#3a
F
#4
#1
#2
#3
#4
#5
H
LOG PLACEMENT