Filter
Top Products
8
W415-0314 / C / 01.15.04
Place the door into the two lower door brackets and secure
at the top of the unit with two #10-24 screws.
FIGURE 16
MANTLE WIDTH
H
E
I
G
H
T
M
A
N
T
L
E
PHAZER
TM
logs, exclusive to Napoleon Fireplaces, pro-
vide a unique and realistic glowing effect that is different in
every installation. Use only certified PHAZER
TM
logs avail-
able from your Napoleon / Wolf Steel Ltd. dealer.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
Position the logs as shown. All logs are numbered.
The rear log should be centred on the log support and rest
against the rear wall.
Log #3 rests against the far left grate post and onto the
locating pin on the centre support. Log #2 rests against
the far right grate post and over the locating pin on the
centre support and against the tip of log #3.
NOTE:
Skewering log#2 onto the locating pin may be necessary.
Log (#6) has a leg that fits into an indentation on the top of
log (#3). Log (#4) rests in the indentations on the tops of
logs (#2) and (#1).
#1
FIGURE 14 a-d
#2
#4
Logs (#5) and (#7) fit onto the indentations of the lower
logs.
#5
#3
#
6
#7
This can vary according to the mantle depth. Use the graph
to help evaluate the clearance needed.
CENTRE SUPPORTLOCATING PIN LOCATING PIN
B
A
C
D
Tear the embers into pieces and place along the front row
of ports covering all of the burner area in front of logs (#2 &
#3). Care should be taken to shred the embers into thin,
small irregular pieces as only the exposed edges of the
fibre hairs will glow. The ember material will only glow
when exposed to direct flame; however, care should be
taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern,
carbon deposits and delayed ignition. PHAZER
TM
logs glow
when exposed to direct flame. Use only certified "glowing
embers" and PHAZER
TM
logs available from your Napo-
leon dealer.
GLOWING EMBERS
FIGURE 15
LOWER DOOR BRACKETS
LOG PLACEMENT
DOOR INSTALLATION
MANTLE CLEARANCE