Filter
Top Products
31
GLOSSARY
Exit/Entry Delays - Separate delays
that let you exit and enter your
premises without setting off an alarm
when the system is armed.
INTERIOR Button - Bypasses
Interior Zones on arming (see Zones -
Interior Zones).
Instant Protection - Arming without
entry delay using the
F button
while remaining on the premises.
Keypad - Puts control-panel
functions at your fingertips. It can be
mounted anywhere in your premises.
Manager's Mode - In a partitioned
system, a low-security operating
mode that allows arming by area.
Panic Buttons - Blue buttons on
the keypad (
G and 7,
8 or 9). If enabled,
pressing
G together with 7,
8 or 9 will alert the central
station of a fire, auxiliary, or police
emergency.
Partitioned System - A system that
has been subdivided into two or more
(up to eight) independent subsystems
(areas).
Pre-Alarm Warning. - A keypad
sounder alert of an impending alarm.
This option is programmable by zone
for the same duration as that
programmed for Abort Delay (see
Abort Delay).
Report - A transmission to a central
station notifying of a change in the
status of the system (alarm, trouble,
low battery, etc.).
RF Low Battery - (Wireless sys-
tems only) Weak transmitter battery.
RF Check In - (Wireless systems
only) Periodic test report from
transmitter (if a report is not received
on time, a supervisory-failure system
trouble will result).
Ringback - A beep after arming
verifying the central-station's receipt of
a closing report.
Service Code - A code intended for
temporary use.
Sounder - A local warning device at
each keypad to alert that (a) entry
delay has started; (b) an attempt was
made to arm with a zone in trouble;
(c) a Day-Zone condition exists (see
Zones: Day Zone); (d) 10 seconds exit
time remaining; (e) invalid code
entered; or (f) central station
acknowledged arming (see Ringback).
System Trouble - A problem (low
battery, power failure, etc.) detected in
the system.
Trouble - A zone fault; an open
door, window, or other problem that
may prevent arming.