10
Disarming the System
1
Enter your premises through the Entry/Exit door. The keypad will sound a steady or pulsing
tone to remind you to disarm the system before your Entry Delay time expires.
2 Enter your User Code and press D. The red ARMED light will go out, indicating that the
system has been disarmed. If you enter an invalid code, the keypad will beep 4 times,
signifying an error. Re-enter your code immediately. 10 seconds before Entry Delay expires,
the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alarm
If the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred while you were
out. Proceed with caution! If you suspect that an intruder may still be on the premises, leave
immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
1 Enter your code and press J. After the system is disarmed, the window will continue
to display “ALARM” followed by the zone(s) violated.
2 To reset the display, note the zones violated, then press C.
Ambush (Optional) Your Ambush Code Type is: TYPE 1 (Prefix) TYPE 2 (Unique)
My Ambush Code is ___________________
If an intruder forces you to disarm your system, enter your Ambush Code and press
J. There are two types of Ambush Codes:
(1) A 2-digit code (prefix) entered just prior to your normal User Code and (2) A separate and unique User Code.
Example Type 1 (Prefix): If your User Code is 1234 and your Ambush Code is 99, press 991 2 34J.
Example Type 2 (Unique): If your User Code is 1234 and your Ambush Code is 8899, press 8899J
Using your Ambush Code will send a silent alarm to the central station. The red ARMED light will go out and the window will display “SYSTEM
READY” as if the system were normally disarmed. There will be no indication that a silent alarm has been sent.
TURNING OFF THE ALARM (DISARMING) WHEN RETURNING
DISARM SYSTEM
ENTRY TIME XXX
INVALID ENTRY
TRY AGAIN
**** ALARM ****
02 - BACK DOOR
03 - LIVING ROOM