Filter
Top Products
JIMMY SERIES HYDRAULIC REBAR BENDERS — OPERATION AND PARTS MANUAL — REV. #9 (01/04/08) — PAGE 8
POWER UNIT TRANSPORTING (Electric-Hydraulic Pump)
■
When transporting of the power unit (pump) is required,
ALWAYS carry unit by its handle.
■
ALWAYS wrap power and remote cable cords neatly to
avoid tripping and damage when transporting.
MAINTENANCE
■
NEVER lubricate components or attempt service on a
operational rebar bender.
■
ALWAYS maintain rebar bender in correct operating
condition.
■
ALWAYS fix damage to the rebar bender immediately
and always replace broken parts. Replace with only MQ
recommended parts.
EMERGENCIES
■
ALWAYS know the location of the nearest
fire
extinguisher
and first aid kit.
■
In emergencies
always
know the location of the
nearest phone or
keep a phone on the job site
.
Also know the phone numbers of the nearest
ambulance
,
doctor
and
fire department
. This
information will be invaluable in the case of an
emergency.
JIMMY SERIES HYDRAULIC REBAR BENDERS — RULES FOR SAFE OPERATION
ELECTRICAL SAFETY
■
ALWAYS test the
ON/OFF
switch on the hydraulic power
unit before operating. The purpose of this switch is to shut
down the rebar bender.
■
NEVER use a extension cord that is frayed or damaged
where the insulation has been cut.
■
NEVER carry the hydraulic power unit by its power cord
or disconnect it by yanking the cord from the power outlet.
■
ALWAYS make certain that the proper extension cord
has been selected for the job. See Table 5.
■
NEVER allow power cord to
lay in wate
r.
■
NEVER
stand in water
while operating the rebar bender.
■
When connecting the hydraulic power unit to a power
receptacle, make sure the receptacle circuit is connected
to either a GFCI receptacle or a receptacle protected by
a 20 amp circuit breaker.
■
When plugging the hydraulic power unit into a power
receptacle, check the nameplate for the correct operating
voltage. Operating the rebar bender at the wrong voltage
will damage the electrical components. ALWAYS read
the nameplate before applying power.
■
This hydraulic power unit is equipped with a 3-prong male
power plug. DO NOT use a 2-prong adapter when plugging
into a wall outlet. This will defeat the purpose of the ground
circuit. If the plug does not fit into the receptacle, contact
a qualified electrician to install a 3-conductor wall
receptacle (outlet).
■
Avoid body contact with grounded surfaces such as pipes,
radiators, ranges and refrigerators. There is an increased
risk of electrical shock if your body is grounded.
■
DO NOT expose the hydraulic power unit to rain or wet
conditions. Water entering the power unit will increase
the risk of electrical shock.
■
When operating the hydraulic power unit outside, be sure
to use the appropriate outdoor extension cord. This type
of extension cord reduces the risk of electrical shock.
■
ALWAYS remove the AC power cord from the power
source before performing any service or maintenance on
the rebar bender. This preventative safety measure
reduces the possibility of accidental starting.