Filter
Top Products
78D0011
37
WDV Series Gas Fireplace
The fireplace and venting system should be inspected before initial use and at least annually by a
qualified field service person. Inspect the external vent cap on a regular basis to make sure that no
debris is interfering with the airflow. Inspect entire venting system to ensure proper function.
Thoroughly clean the inside of the glass door after using the fireplace for two hours. Periodically clean
the glass door as necessary.
When cleaning the glass, remember:
• Allow glass to cool before removal.
• NEVER use abrasive materials.
• Keep children and pets a safe distance away.
• Never operate the fireplace without the glass door properly secured.
• Never operate the fireplace if the glass is broken.
• Replace any glass that is chipped, cracked, or broken. Replacement glass door assemblies MUST
be supplied by the fireplace manufacturer –
• Handle glass door with care to avoid striking or scratching it on hard objects.
To clean glass door, follow “Glass Removal” procedure outlined in the Final Installation section. Film
deposit on the inside of the glass should be cleaned off using a nontoxic, non-corrosive, non-abrasive,
mild-cleaning solution. Simply apply an adequate amount to the glass and wipe off with a damp cloth.
After all maintenance has been completed, re-install glass door.
Vacuum surface of the stones with a brush attachment. If stones must be removed for cleaning, handle
carefully by holding gently at each end. Gloves are recommended to prevent skin irritation from ceramic
fibers. If skin becomes irritated, wash gently with soap and water. Vacuum surface of stones with brush
attachment or brush logs with a soft bristly (i.e. clean, dry paintbrush). To place stones in the fireplace,
refer to Stone Placement section on Page 27.
Do not use fluids to clean ceramic fiber stones.