Filter
Top Products
78D0011
29
WDV Series Gas Fireplace
1. Read the safety information above.
2. This appliance is equipped with an ignition device which automatically lights the burner. Do not try
to light the burner by hand.
3. With five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell
gas, Follow "B" in the safety information on Page 26. If you do not smell gas, go to next
step.
4. Install four (4) "AA" batteries (provided in your Homeowner's Manual bag) into the command center
box. Make sure the batteries orientation match.
5. Press the master switch to the "ON" (-) position. Within eight (8) seconds it will beep once. This
indicates the system is ready.
6. Press "ON " button. Sparker will spark and pilot flame will light.
7. Once pilot flame is established, the main burner flame will light automatically.
8. If the pilot will not stay lit after several tries, turn the master switch to "OFF" and call your service
technician or gas supplier.
1. Turn master switch to "OFF".
2. Turn off all electrical power to the appliance if service is to be performed.
FP1913
Switch box
8/08
ON
Master
Switch
OFF
FP1914
Pilot w sparker
8/08