Filter
Top Products
25MS9470/MS9770/MS9970
The security system can be disarmed by means of the KR21 and SH624 remote control or by using your PIN on the keyboard
of the SC2800 base station.
1. Disarming via the keyboard of the SC2800 base station:
Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press
Press the DISARM button: Dual tone confirmation. ARM indicator goes out or flashes when an alarm was detected previously.
2. Disarming the system using the KR21 key chain remote control:
Press the DISARM button: Dual tone confirmation. ARM indicator goes out or flashes when an alarm was detected previously.
3. Disarming the system using the SH624 system remote control:
Press the DISARM button: Dual tone confirmation. ARM indicator goes out or flashes when an alarm was detected previously.
6.4 DISARMING THE SYSTEM
You disarm the system in the same way as described under 6.4.
Base station:
The ARM indicator on the base station will be flashing when an alarm situation has occurred. The zone-indicator panel will
tell you which zone caused the alarm situation. After an alarm, you can reset the system by keying your PIN and pressing the
DISARM button. The flashing ARM and zone indicator will now go out.
Home Automation modules:
When the security system is armed and an alarm situation occurs, the lights connected to the Lamp Module LM12 will be
switched on and off continuously (flashing). For more information refer to 6.8. After approx. 4 minutes the siren in the
SC2800 base station stops and the lights are going on continuously. When you disarm the system these lights are
switched off.
6.5 DISARMING AFTER AN ALARM
SITUATION