Filter
Top Products
16 MARMITEK
Up to 8 remote controls can be registered with the base station (KR21 and SH624).
Every time you press a key you hear a short confirmation beep.
1. Set mode switch to the INSTALL position: All indicators of occupied zones come on
2. Press an alarm key (e.g. DISARM) of the first remote control (e.g. KR21): No extra zones are occupied.
3. Press an alarm key (e.g. DISARM) of the second remote control (e.g. SH624): No extra zones are occupied.
4. Repeat these steps up to 8 remote controls.
5. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out
You can use your security system without the siren (only telephone dialler and lights). In case of a break in, the siren built
into the base station will not be activated. (N.B.: Extra external sirens will always be activated). The factory defaults have the
siren switched on.
Every time you press a key you hear a short confirmation beep.
1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on
2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8).
3. Press key number 4.
4. Press ENTER.
5. Press 0 for silent alarm: double confirmation beep
or
Press 1 for alarm with siren: double confirmation beep
6. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out
5.2 REGISTRATION OF WIRELESS
REMOTE CONTROLS
5.3 SETTING THE SIREN ON/OFF
(LOUD/SILENT ALARM)