Filter
Top Products
30 Optional Equipment
© Travis Industries 100-01163 4041129
3. Attach the retainer to the shell following the directions below.
Make sure the door retainer is centered on the door shell.
You can gauge the alignment by looking at the gaps here.
Once the door is aligned, tighten
the two set screws on the bottom
of the door shell to secure the
door retainer.
1/8” Hex Wrench
4. Attach the door handle
following the directions to
the right.
5. Replace the door on the
hinges and latch the door.
6. Attach the ashlip trim and
side frames following the
directions below.
9/16" Wrench
NOTE: in rare cases the door retainer may not line up with
the door shell, preventing the door handle from lining up
correctly. To adjust the position horizontally, loosen the set
screws (see step 3) and adjust the door retainer position. To
adjust vertically, remove the retainer and adjust the clips on
the door shell (see step 2).
Slide the ashlip trim
into place then
tighten the five set
screws on the
bottom of the ashlip
to secure.
1/16” Hex Wrench
Insert the screws
through the face and
nuts (the nuts are used
as spacers) and secure
to the side frames.
Side Frame
5/16”
Socket