Filter
Top Products
Optional Equipment (for qualified installers only) 41
© Travis Industries 4060111 100-01174
Accent Light
Make sure power to the heater has been turned off prior to installation (unplug the power cord).
Do not connect 110-120 VAC to the gas control valve or the on/off circuit on this fireplace.
IMPORTANT INSTALLATION NOTE FOR MODELS USING THE FIREBACKS:
Follow the steps below if installing the firebacks with an accent light.
• Remove the burner.
• Install the rear fireback.
• Install the accent light.
• Replace the burner.
• Install the side firebacks.
1 Remove the burner (see the manual for details).
2 Install the accent light and remove the cover plate as shown below.
Remove this screw, position the
accent light assembly in the same
location, and attach with the same
screw.
Remove this cover plate and
gasket.
a
b
NOTE: Once the light is in
place, remove the protective
covering. Do not touch the
halogen bulb - this may lead to
premature bulb failure.
NOTE: The cover plate is
here on the DVS.
NOTE: On the DVS, make
sure to use the lower screw.
NOTE: To prevent heat-damage to the
wires, make sure this clip holds the
wires down, away from the burner.
3 Attach the wire plate as shown below.
Route the wires from the accent
light through the gasket and
firebox floor. Use the screws
removed in step “2” to attach the
wire plate to the firebox floor
(make sure the gasket is
properly aligned).
Wire Plate
Once the wire plate is in
place, pull the excess
wire through the
grommet, towards the
front of the insert.
a
b