Filter
Top Products
6
A. Assembly
1. Attach the collector assembly to the base unit:
• Bolt the collector assembly to the frame with 4 sets of
bolts, washer, and nuts
• Slide the rectangular end of the collector over the housing
and mount the flange with 2 sets of washers and nuts
2. Attach the throttle control cable to the handle on the
collector assembly:
• Bolt throttle control lever to handle with washer and nut
• Secure throttle cable to handle with cable ties in 2 places
3. Install the band clamp into the debris bag (wear gloves
when handling band clamp):
• Slide the bracket end of the band clamp through the left
side opening of the sleeve on the debris bag until it
emerges from the right side
• Feed the tail end of the band (on the clasp side) behind
the bracket in the sleeve
• Pinch the wire form on the clasp together and connect it
through 2 holes in the adjustment bracket such that it will
close tightly over the collector
4. Connect the debris bag by placing it over the bottom lip of
the collector and closing the clasp to secure the bag. Adjust
the clasp wire form to the appropriate hole position on the
bracket to insure a tight fit. If the bag will not fit tight within
the range of the 3 adjustment holes, insert the bag seal strap:
• Unhook the wire form from the bracket
• Pull the tail end of the
band back out from
behind the bracket
• Feed one end of the seal
strap behind the metal
band and through the
channel to the other side
• Tuck the other end of
the seal strap behind
the bracket
(overlapping the lead
end of the seal strap)
• Feed the tail end of the
band clamp behind the
bracket (overlap the
seal strap)
• Connect the wire form
to the appropriate holes
in the bracket and
secure the debris bag to
the collector
5. Attach nozzle assembly to
base unit:
• Attach one end of the
hose to the nozzle
assembly with the
bridge clamp
• Slide the other end of
Assembly Instructions
the hose over the edge of the inlet on the front plate
• Hook one side of the nozzle bracket over the front axle
• Bend the other end of the nozzle bracket inward to
hook it over the axle and engage the pins on the wheel
bracket with the slots on the nozzle bracket
• Secure the hose to front plate inlet with the bridge
clamp
• Attach the nozzle cable end fitting through the hole in
the nozzle bracket
6. To remove nozzle assembly (for purposes of storage, or
clearing blockages):
• Turn engine off and disconnect spark plug
• Loosen hose clamp on the front plate with flathead
screwdriver or 5/16 wrench
• Slide hose off of front plate inlet
• Bend one side of nozzle bracket inward and twist the
assembly to remove the hook from the axle
• Twist back and lift to remove the other side of nozzle
bracket from the axle
WARNING DANGER
NEVER RUN OR OPERATE YOUR MACHINE
UNLESS DISCHARGE BAG IS ATTACHED,
AND THE INTAKE NOZZLE IS INSTALLED.