Filter
Top Products
13
Tools Needed: 5/32” Allen Wrench or T-Handle
Cat. No. Description
H5746 Shoreline Door Assembly
(Figure 9)
1. Locate the three bottom tabs on the bottom of the door. These tabs
on the bottom of the door will insert in the slots along the bottom of
the insert. See Figure 10.
2. Drop the door into these three slots on the bottom of the insert as
shown in Figure 11. Once this is done you can then rotate the door
up to seal against the firebox front.
3. Using the 5/32” Allen Wrench or T-Handle insert the three 10-24 screws
with washers into the three locations on the upper latch assembly. You
can then tighten the screws down by turning the wrench or T-Handle
clockwise (SNUG ONLY-DO NOT OVERTIGHTEN). See Figure 12.
4.
Figure 13 shows the insert with the door in place.
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Shoreline Door Kit - Packaging List
Models SHR33 & SHR40
Quantity Description
1
Shoreline Door Assembly
Table 6 - (refer to Figure 9)
Note: The Shoreline insert comes with the door already on the unit.
Just reverse the steps here to remove the door to access the burner
area.
SHORELINE™ DOOR ASSEMBLY INSTALLATION OR REMOVAL
INSTRUCTIONS
Upper Latch Tabs
Bottom Tabs
See Detail B
Detail B
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
See Detail E
Detail E
See Detail C
Detail C