Filter
Top Products
- 5 -
4. Close the battery compartment
t
. The battery compartment lid must close
with an audible click.
Measuring distances
1. Slide the function switch
q
to „Distance“. The display
2
switches itself on.
To switch between the metric and the Anglo-American units of measurement,
press and hold the button MODE
4
. Then press the button READ
6
and release
both buttons simultaneously. When you release the buttons, the measurement
units change.
Note:
Measurements start at the measurement point
1
!
Should the measurement lie outside the measurement range, „Err“ or an illogical
number appear in the display. The measurement range lies between 0,6m (2“)
and 16m (53“).
2. Hold the appliance upright towards the wall to which you wish to measure
the distance. The ultrasound sender/receiver
0
must be at a right-angle to
the wall. For this, use the spirit level: The bubble in the glass
8
must stand
between the marking lines (see Fig.1).
3. Press the button READ
6
. The distance measured appears in the display
2
.
When you hold the button READ
6
pressed down and slowly move the
appliance over the surface to be measured, the appliance continually
measures the distances. These are shown on the display
2
.
Take note of the following illustrations:
Fig.1 Fig. 2
The further you are from the wall, the wider is the area (a) that the Multi-
Measurement Detector must measure by ultrasound (Fig. 2). Therefore take care
that the Manifold Measurer is always directed at a right angle towards a level
surface (Fig.1 and 3). Ensure that there are no objects positioned within the
measurement area.
IB_KH3236_BN3376_GB_LB4u5 29.02.2008 18:06 Uhr Seite 5