Filter
Top Products
- 9 -
Fig. 4
6. Now repeat the procedure, but this time approach the object from the other
side. As soon as the signal tone sounds, mark this position (see Fig. 4).
The concealed object runs between these two positions.
Locating wood objects
1. Proceed with the search for wood objects as described in the section
„Locating concealed objects“.
2. When the Multi-Measurement Detector has found an object, mark it.
To be sure that the object is wood, slide the material switch
3
to METAL.
3. Now search in the same position for metal. Should the Multi-Measurement
Detector not find anything, then the object is wood. Should it find something,
then the object is metal.
In this case, search again at a different position in the mode „STUD“ and repeat
steps1 to 3.
IB_KH3236_BN3376_GB_LB4u5 29.02.2008 18:06 Uhr Seite 9