Filter
Top Products
- 6 -
False!
(Fig. 3)
The display illumination glows during the measurement. If a button is not pressed
within ca.15 seconds, the illumination extinguishes. After a further ca.15 seconds
the diplay itself switches off. Press the button READ
6
, to reactivate the display
and the illumination.
Note:
Inaccurate measurements can also occur through a weak battery.
If the battery is too weak, the battery symbol appears in the display.
Adding distances together
You can add the measured distances together:
1. Measure the first distance as described.
2. Press the button +/=
r
. In the display
2
, „+“ appears and the distance
measured carries itself over to the lower line.
3. Measure the next distance. The newly measured distance is shown in the
upper line.
4. Once again, press the button +/=
r
. The new measurement is added
to the old measurement in the lower line.
5. Repeat steps 2 to 4 to add further measurements.
6. When you wish to leave the addition mode, press the button MODE
4
.
All values are erased.
Measuring areas
1. Slide the function switch
q
to „Distance“.
The display
2
switches itself on.
2. Press the button MODE
4
once. In the display
2
flashes „L“ (Length).
IB_KH3236_BN3376_GB_LB4u5 29.02.2008 18:06 Uhr Seite 6