Filter
Top Products
16
Electrical Shock Hazard can
occur and result in serious injury or death.
Disconnect appliance from electric power before
cleaning and servicing the warmer drawer.
To Remove Warmer Drawer:
1.
Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide
lever and push down on the right glide lever (See Fig.1).
5. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pull the bearing glides to the front of the chassis glide
(See Fig. 2).
2. Align the glide on each side of the drawer with the glide slots on
the range.
3. Push the drawer into the range until levers “click” (approximately
2”). Pull the drawer open again to seat bearing glides into position.
If you do not hear the levers “click” or the bearing glides do
not feel seated remove the drawer and repeat steps 1 thru 3.
This will minimize possible damage to the bearing glides.
Fig. 1
Fig. 2
Setting Warmer Drawer Controls (cont’d)
Self-Cleaning
During the Self-Cleaning cycle, the outside of
the range can become very hot to the touch. DO NOT leave
small children unattended near the appliance.
The health of some birds is extremely
sensitive to the fumes given off during the Self-Cleaning
cycle of any range. Move birds to another well-ventilated
room.
DO NOT line the oven walls, racks, bottom
or any other part of the range with aluminum foil. Doing so
will destroy heat distribution, produce poor baking results
and cause permanent damage to the oven interior
(aluminum foil will melt to the interior surface of the oven).
DO NOT force the oven door open. This can
damage the automatic door locking system. Use caution
when opening the door after the Self-Cleaning cycle is
completed. The oven may still be VERY HOT.
Self-Cleaning Oven
A Self-Cleaning oven cleans itself with high temperatures
(well above cooking temperatures) which eliminate soils
completely or reduces them to a fine powdered ash you can
wipe away with a damp cloth.
Adhere to the following cleaning precautions:
• DO NOT use oven cleaners or oven protective coatings
in or around any part of the Self-Cleaning oven.
• DO NOT clean the oven door gasket. The woven
material of the oven door gasket is essential for a good
seal. Care should be taken not to rub, damage or
remove the gasket.
• DO NOT use any cleaning materials on the oven door
gasket. Doing so could cause damage.
• Remove the broiler pan and insert, all utensils and
any aluminum foil. These items cannot withstand
high cleaning temperatures.
• Oven racks should be removed. If they are not removed
during the Self-Clean cycle their color will turn slightly
blue and the finish will be dull. After the cycle is
complete and the oven has cooled, rub the sides of the
oven racks with wax paper or a cloth containing a small
amount of salad oil (this will make the racks glide
easier into the rack position).
• Remove any excessive spillovers in the oven cavity
before starting the Self-Cleaning cycle. To clean, use
hot, soapy water and a cloth. Large spillovers can
cause heavy smoke or fire when subjected to high
temperatures. DO NOT allow food spills with a high
sugar or acid content (such as milk, tomatoes,
sauerkraut, fruit juices or pie filling) to remain on the
surface as they may leave a dull spot even after
cleaning.
• Clean any soil from the oven frame, the door liner
outside the oven door gasket and the small area at the
front center of the oven bottom. These areas heat
sufficiently to burn soil on. Clean with soap and water.