Filter
Top Products
Operating Instructions
Delay Start Operation
To program delay start:
1. Turn unitoff(pressOFFpad).
2. Press DELAY START pad. Display flashes currently
programmed temperature setting.
3. Program new temperature setting (if desired) using
Vl Apad.
NOTE: Current temperature setting is used if not
changed within 5 seconds.
4. Select desired operating mode and fan speed.
5. Press DELAY START pad. Display flashes currently
programmed delay time_l through 24 (hours).
6. Program new delay time (if desired) using V I/_
pad.
NOTE: Current delay time is used if not changed within
5 seconds.
7. Press DELAY START pad to start timer. Display
shows time remaining until unit automatically starts.
At programmed time, unitautomatically starts in
programmed operating mode.
NOTE: Timer automatically starts after 5 seconds if
DELAY START pad is not pressed.
To program automatic stop:
1. Start air conditioner in desired operating mode. If
unit isalready in desired mode, go to step 2.
2. Press DELAY START pad. Display flashes currently
programmed time_l through 24 (hours).
3. Program new time (it desired) using V I A pad.
NOTE: Current time is used if not changed within 5
seconds.
4. Press DELAY START pad to start timer. Display
shows time remaining untilunit stops. When
programmed time elapses, unit automatically stops.
NOTE: Timer automatically starts after 5 seconds if
DELAY START pad is not pressed.
To cancel delay stop program, press DELAY START pad
after timer starts counting down, or turn unit off (press
OFF pad).
Adjusting Airflow Direction
See Figure 38. Position ofair discharge vent louvers
determines directionof airflow from vent. Direction can
be adjusted upward, downward, left, and right.
Figure 38. Airflowfrom AirDischarge Vent
1. Airflow directioncontrollever
2. Air dischargevent hodzontal louvers
2
To adjustairflowupwardor downward, move horizontal
louvers on outsideofair discharge vent up or down.
To adjust airflowleft or right,move airflow directioncontrol
lever leftor right.
Energy Saving Tips
In additionto operatingairconditioner in energy-saving
mode, savings of energy and money can be realized by:
• Increasing insulationin walls and ceilings.
• Closing all heating and ventilation diffusers or vents
(including furnace coldair retum vent) in area being
cooled.
• Closing drapes or blindson windows that receive
direct sunlight. Installwindow coverings or awnings
on windows not currently covered.
• Adequately ventilating attic. Heat build-up in atticadds
to air conditioner cooling load.
• Avoiding use of heat-producing appliances during
hottest parts of day.
• Turning off lightsand appliances when not needed.
• For maximum efficiencyand cooling, vent doorshould
be closed whenever air conditioner is cooling.