Open as PDF
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
6. Press SELECT again to display the “Gallons or Liters”
GALLON OR LITER READINGS: Water usage and
flow rate displays are shown in gallons at the default
setting. If you prefer liters, change this setting from
“Gals” to “Liter” by pressing the r UP button.
7. Press SELECT again to display the “Recharge Days”
MAXIMUM DAYS BETWEEN REGENERATIONS: The
electronic controller automatically determines regen-
eration fre quency. This provides the greatest operat-
ing efficiency and, under most conditions this feature
will be left in its default mode. However, you can set
this feature to force a regeneration every set number
of days. You may want to do this if, for exam ple,
your water supply contains iron and you want the
softener to regenerate at least once every few days
to keep the resin bed clean. Use the r UP or s
DOWN buttons to change the number of days (up to
15). If no change is desired, continue to next step.
8. Press SELECT again to display the “Backwash Time”
BACKWASH & FAST RINSE TIMES: If you experience
salty tasting water after regeneration, you may need
to increase the backwash and fast rinse times. The
default backwash time is 13 minutes and the default
fast rinse time is 6 minutes. However, you may
increase or decrease the backwash and fast rinse
times, in 1 minute increments.
If you wish to change the backwash time, use the r
UP or s DOWN buttons to set the backwash time
between 1 and 30 minutes. Then press SELECT to
display the “Fast Rinse Time” setting screen.
If you wish to change the fast rinse time, use the
r UP or s DOWN buttons to set the fast rinse
time between 1 and 30 minutes.
9. Press SELECT to return to the normal run (time of
A light inside the salt storage tank will come on when-
ever you open the salt lid. A “Tank Light” icon is dis-
played when this light is on. The light turns off when
you close the salt lid. It will also turn off automatically
after 15 minutes if the salt lid is left open.