18
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
Controller Features
Figure 28
Figure 27
2. Press SELECT again to display one of the “Clean”
screens shown below.
CLEAN: This feature is beneficial on water supplies
containing iron and/or high amounts of sediments
(sand, silt, dirt, etc.). When set to ON, a backwash
and fast rinse cycle will occur first, preceding the
normal regeneration sequence. This provides extra
cleaning of the resin bed before it is regenerated
with the salt brine. To conserve water, if your water
supply does not contain iron or sediments, be sure
this feature is set to OFF. The default is OFF. Use
the r UP or s DOWN buttons to change between
OFF and ON.
3. Press SELECT again to display the “Clean Time”
screen shown below.
CLEAN FEATURE MINUTES: If you have set the
Clean Feature ON, the length of the extra backwash
cycle auto matically is set to 2 minutes. However, you
can ad just this time from 1 to 15 minutes in length.
To change this cycle time, use the r UP button to
increase the time, or the s DOWN button to short-
en the time. If no change is desired, continue to next
step.
Figure 30
Figure 29
4. Press SELECT again to display the “97%” screen.
97% FEATURE: The 97% Feature can save salt and
water by regenerating when 97% of the softener’s
capacity has been used up. With this feature ON,
the regeneration can occur at any time (whenever
the system has reached 97% of its capacity). The
default is OFF. If this feature is desired, turn it on by
pressing the r UP button.
5. Press SELECT again to display the “12 or 24 hr”
screen.
12 OR 24 HOUR CLOCK: All time displays are shown
in standard clock time (1 to 12 AM; and 1 to 12 PM)
at the 12 hr default setting. If 24 hour time format is
desired, set to 24 hr by pressing the r UP button.