Kenmore 625.38426 Water System User Manual


 
T--
A
1
b--F---.1
I I
I I
I
I
I
I
I
1 ]
[
C
E
D
'r T
Inches cm
A Salt Tank Height 34 86.4
B Resin Tank Diameter 10 25.4
(nominal)
C Resin Tank Height (nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 48 121.9
F1 Length 21 53.3
F 2 Width 17 43.2
- Distance between inlet-outlet 3-3/4 8.6
centerlines
BYPASS VALVES
Bypass valve(s) should always remain in soft water
service position. Position in "bypass" only if needed for
softener repairs.
SINGLE BYPASS
pull stem
outward for
service
push
inward for
bypass
3 VALVE BYPASS Bypass
FOR SERVICE valve
close bypass valve
open inlet & outlet valves
FOR BYPASS Outlet
open bypass valve Inlet
close inlet & outlet valve
FIG. 59
MODEL NO. 625.384260 - TIMER CODE H46
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm) 3
Minimum-maximum water pressure (psi) 20 - 125
Minimum-maximum water temperature (°F) 40 - 120
Maximum water hardness (gpg) 160
Maximum "clear water" iron (ppm)* 11
SALT FOR WATER SOFTENER
Type of salt needed nugget
Alternate type of salt pure, evaporated, compacted
water softener salt
gpm = gallons per minute gpg = grains per gallon
psi = pounds per square inch ppm = parts per million
* Capacity to remove clear water iron is substantiated by WQA test data. State of Wisconsin requires
additional treatment if water supply contains greater than 5 ppm clear water iron.
Questions? Call The Kenmore Water Line 1-800-426-9345
36