Filter
Top Products
SECTION 5 SERVICE TECH INFORMATION
! I
5C. WATER FLOW THROUGH THE SOFTENER VALVE
BRINING AND BRINE RINSE CYCLES
bypasshard water
to valve outlet
venturi
nozzle
-_ from Valve Inlet
• "" (hard water)
brine from
saltstor-
agetank ,_ _ -,,& ___
, _ , !
_ iin
switch
a
After flU, timer/switch action allows the motor to turn the rotor and disc into
BRINING position. Water flow is directed to the nozzle. Suction, created by the
nozzle and venturi, draws brine from the salt storage tank and injects it into the resin
bed via the bottom distributor. Flow continues out the top distributor and to the
drain. Hard water is available at the valve outlet.
When the brine valve closes to end brine draw, water flow continues in the same
directions to slowly RINSE brine from the resin bed and to the drain.
bypass hard water
to valve outlet
f
BACKWASH CYCLE
drain
Timer/switeh action again allows the motor to tom the
rotor & disc to place the valve in BACKWASH, stopping
water flow to the nozzle. Water is routed down and out
the bottom distributor, up through the bed, and out the
top distributor to the drain. The fast flow (controlled by
a flow plug in the drain fitting) flushes dirt, sediments,
iron deposits, remaining brine and hardness to the
drain.
iin
switch
27