Kenmore 625.34867 Water System User Manual


 
SECTION 3 CAREOFYOURSOFTENER
3D. HELPFUL HINTS CHECKLIST
... TO HELP YOU SAVE MONEY
If your water softener fails to work, make the following easy checks. Often, you will find what's wrong yourself
and you won't have to call and wait for service. If you do not find anything wrong, while making the checks, and
your softener still does not work, call your Sears Service Department.
NOTES:
1. Also read ERROR CODE, page 12.
2. If an error code is not displayed, press and bold the #1 SELECT button until the display changes. Then, press the
#1 SELECT button again and bold until a flashing HF code appears. It must show I-IF32. If any other number shows,
the face plate computer is working on incorrect input and would probably be the cause of the problem. To set
ITF32, press either the UP I_ or DOWN _ button. When HF32 shows, press #1 SELECT button to return a
flashing 12:00 AM display. Reset the present time, hardness number, etc., pages 6 and 7.
PROBLEM CAUSE CORRECTION
No soft water No salt (or salt bridged) inthe storage tank Refill with salt, or break the salt bridge (page
16). Press ON/OFF-HOLD (RECHARGE
NOW) buttonand holdfor 3 seconds to start a
regeneration (see page 10).
Transfomer unplugged at the wall outlet, Check for loss of power due to any of these
or power cable leads loose, fuse blown, and correct. With the power back on, look at
circuit breaker popped, or circuitswitched the time display and read PROGRAM
off. MEMORY, page 12.
Manual bypass valve(s) in bypass position Look at FIG. t2 on page 20. Move the stem in
a single valve to service. In a 3-valve bypass,
open the inlet and outlet valves, and be sureto
fully close the bypass valve.
Dirty, plugged or damaged nozzle & Take apart and clean or replace damaged
venturi parts (see page 17).
Valve drain hose plugged The drain hose must not have kinks, sharp
bends, or be raised too high above the
softener (see page 16 in your installation
manual.
Water hard sometimes Hardness number setting too low Press and release the #1 SELECT button untU
HARDNESS shows in the display. Read the
hardness number in the display and be sure
the same grains per gallon number is shown
on your water analysis report. See page 7 to
reset. Press and release the SELECT button
until the present time shows in the display.
Using hot water when softener is Avoid usinghotwaterduringthistimebecause
regenerating the water heater refills with hard water (see
Automatic Bypass, page 15).
Increase in the grains of hardness in your Ask your Sears retail or catalog store fora new
water supply water analysis. Then make a new hardness
number setting (page 7).
19