Filter
Top Products
SECTION 2 .ow YOURWATERSOFTE.ERWORKS
2A. FACEPLATE TIMER FEATURES
OPTIONAL ADJUSTABLE SETTINGS
Following is a list of other timer features that are
adjustable, and the default setting for each. The
defaults automatically set when electrical power is
applied to the timer. If you want to change from any of
the default values, scroll through steps 1 - 5 below,
and reset as desired.
1. Press and hold the #1 SELECT button for 3 seconds
until the faceplate display changes. Then, press and
release the #1 SELECT button to display 12 hr
• 12 or 24 Hour clock - defaults to 12 hr: At the
12 hr default setting, all time displays are shown in
standard clock time (1 to 12 PM; and 1 to 12 AM). If
military time displays are desired (0100, 0200, etc.), set
to 24 hr by pressing the UP button.
[ii{i:-[i{:i
2. Press #1 SELECT BUTTON
• Gallon or Liter readings - defaults to gal-
Ions: Water usage and flow displays are shown in gal-
lons. If you prefer to have the same displays in liters,
press the UP button until Liter shows.
t_va _t _: teat
.... ItxE,-
3. Press #1 SELECT BUTTON
• Maximum Days Between Regenerations -
default is zero days: The faceplate timer automati-
cally controls regeneration frequency (see page 14).
This provides the greatest operating efficiency, and
normally the maximum days feature is not needed.
If you want to be certain a regeneration will occur
within a number of days, use this feature. For
example, if your water supply contains iron and you
want the softener to regenerate at least once every few
days to keep the resin bed clean, set the display as
typically shown below. Setting is available from 1 to 15
days by using the UP and DOWN buttons.
NOTE:
Setting a number in this display may override the
function of the water meter and timer computer
(see page 15). For example, assume the meter/com-
puter would initiate softener regenerations every 6 or
7 days. If you have max days set to 4, as shown below,
regenerations will occur every 4 days instead of every
6 or7.
I_"i I l_'i _ _exa
_==_nc._ _*P'_ mpte:set to
" _' _ 4 days maxi-
I mum between
..... J regenerations
default display
4. Press #1 SELECT BUTTON
• CLEAN feature minutes - default is 7
minutes: If you have set this feature to ON (page 7),
the length of the extra backwash cycle automatically
sets to 7 minutes. However, you can adjust this time
from 1 to 15 minutes in length. If you have a minimum
of iron or sediments, a 3 or 4 minute clean cycle may
be enough to keep the resin bed clean. If you have a
higher amount of iron or sediments, a setting of over 7
minutes may he needed. To change this cycle time, use
the UP button to increase the time, or the DOWN
button to shorten the time.
7
8 I m
7
6 CtBU¢
5
4
3
default minutes
CLF-At¢tlW
example: time set to 3 minutes
5. Press #1 SELECT to return the present time
display.
11