Filter
Top Products
17
Flat
side
away
from
you
Fig. 1
! j
Foot ho 1
Fig. 2
Foot
thumb
screw
CHANGING NEEDLE
Raise needle bar to its highest position by
turning the hand wheel toward you. Loosen
the needle clamp screw. Holding the needle
with the flat side away from you, slip the
needle into the needle bar. When it is in as far
as it will go, tighten the needle clamp screw
with small screwdriver provided in the
accessory box.
PRESSER FEET
This machine is supplied fitted with a zigzag
presser foot for general sewing purposes.
In the accessory box are the following
additional presser feet:
1. Straight stitch foot
2. Metal and plastic satin stitch feet
3. Buttonhole foot
4. Built-in buttonhole guide foot
5. Zipper foot
6. Blind hem foot
7. Overcasting foot
8. "Q FOOT",+
9. Even feed foot
10. Narrow hemmer
11. Edge stitcher
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise
presser foot lever.
Snap-on presser feet
1. Raise foot release lever to remove the
foot. (Fig. 1)
2. Place the desired foot on the needle plate
aligning needle holes. (Fig. 1)
3. Lower the presser foot lever so that the
foot holder snaps on the foot. (Fig. 2)
One-piece presser feet
1. Loosen presser foot thumb screw and
remove the foot holder.
,
Insert desired foot from the front. Lower
the presser foot lever and tighten the
screw using the large screw driver to
make certain the foot is secure.