Filter
Top Products
II
THREADING TOP THREAD
Fig, 1
Fig. 2
A
D
\
\
Fig. 3
1. Raise slotted take-up lever to its highest
position.
Place thread spool onto spool pin. Place
appropriate spool cap over the spool of
thread.
Draw thread through rear thread guide
(A) and into threading channel (B) toward
you. (Fig. 1)
2. Draw thread down and around check
spring (C) and up through slotted take-up
lever (D). (Fig. 2)
3. Draw thread down into thread guides (E)
and (F). Thread needle from front to back
as shown in Fig. 3.
THREADING DOUBLE NEEDLE
Place second spool of thread on second
spool pin, and thread machine as you would
for a single needle except double thread
guides are provided, Draw one thread
through each of these and through each side
of needle from front to back.
0