Filter
Top Products
SECTION3 STEP BY STE P G UIDES TO INSTALL
F. GROUNDING / CONNECT TO ELECTRICAL POWER
_PLUG IN THE TRANSFORMER CONNECTING TRANSFORMER
Plug the transformer into the electrical outlet.
Transformer
120V-6OHz
Electrical
Outlet
from Face Plate-_mer
INSTALL COVERS
tabs
After installing your water softener, replace the cov-
ers. For the UltraSoft 400 and UltraSoft 800, angle
the covers so the main cover clips onto the back first,
then bring down in front and clip on the 2 tabs inside
the rim of the salt hole and lower the salt cover clo-
sed.
RESTART THE WATER HEATER
TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT
Your new Sears softener is now softening the water
for your household needs. However, your WATER
HEATER is filled with hard water. To have fully
soft water right away, you can drain the water heat-
er so it refills with soft water. If you don't drain the
water heater, it will take a few days before you have
fully soft water.
To drain the water heater, open a hot water faucet
and let it run until the water runs cold. Then close
the faucet.
YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.
Now go to your owner's manual and do the softener start-up steps...setting the timer, filling the
storage tank with salt, sanitizing, etc.
3-9
High Performance Valve